I have the plugin set up so that players do not need to have a foundation to add a home but cannot place them near monuments.

I have a player who is unable to set a home (in a base) on this ice lake at D12, from what I can see its not close enough to any monuments to be triggering the block.

I've tried multiple options adding to this line to try and disable it but have not have any success. Is there anyone else that has had this issue and knows a workaround?

    "Allow Sethome At Specific Monuments": [
      "HQM Quarry",
      "Stone Quarry",
      "Sulfur Quarry",
      "Ice Lake/Frozen Lake/Lake/???" 

Ignore Monument Marker Prefab

set this true.

if this doesn't work then you will need to figure out the monument name.

the /spm command may show it

I cannot remember a time when you could build on the frozen lake(s) on a rust map ?

Merged post

*Edit , seems they must have changed it , have not tried building on one for a while under the misconception that you could not build on the frozen lakes (with island in middle) , There are three frozen lakes on the map (i am using) and i was able to set a home on them. even the one with the small island in the middle.

nivex

Ignore Monument Marker Prefab

set this true.

if this doesn't work then you will need to figure out the monument name.

the /spm command may show it

Tried setting it to true and tested again, its 100% the lake stopping it as I was able to set a home ~20m around the edge of it in all directions just not on top.

/spm shows this:

Bit of a mystery this one, even the river below is in the shape of a question mark lol!

Here is the map on RustMaps.com

That worked for us:

},
"Allow Sethome At Specific Monuments": [
"HQM Quarry",
"Stone Quarry",
"Sulfur Quarry",
"Ice Lake"

and I also set this one:

"Allow Iceberg": true,

But I don't know if that is necessary. :-)

I know this is an old thread but I'm now seeing this issue as well. I have allow Ice Bergs and I put "Ice Lake" in "Allow Sethome At Specific Monuments" and I have set "Ignore Monument Marker" to true. 

I have no such issue using the settings above