Door controllers, and therefore their connections to the main circuit disappear when pasting.

Original door 1:
https://gyazo.com/d75ab82686a5c82310e306044efe8ac8
Original door 2:
https://gyazo.com/b254e20a11e4a7afc6172f9cffb8e250
Original control room:
https://gyazo.com/b941c7851426dc87fb786142c5eba6ad

Pasted door 1:
https://gyazo.com/0ea6e7e8d0c027c56b3d30080b5a39c5
Pasted door 2:
https://gyazo.com/0661b66193f603d37f6a546c832bfcc5
Pasted control room:
https://gyazo.com/e1471943544b731e2760ca91cb7d1eed


For now i'm just labeling those coneccions that disappear. but labelling is annoying and takes up a lot of space.
If anyone knows a better way for labelling i'm all ears.
https://gyazo.com/e9392eddf10d709f68bb75ac3cb535aa

I have added some branches near all the doors that use a controller so I just quickly plug in from there rather than this mess

1. Same here. No fancy electrical stuff, just the door controllers missing on a single door. :(
2. CodeLocks and KeyLocks are sometimes set to open/green when pasting